WARNING: This product can expose you to chemicals known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Notes: For more tongue relief and the Level 3 version of this bit, see the MB 33. For a correctional with ample tongue relief, see the MB 41PBW. For a correctional bit with more tongue pressure, see the MB 41PB or MB 27PB.

The Western Dee with Hooks is a circular stainless steel ring with fixed attachment of the mouthpiece, with top and bottom rings (“hooks”) for headstall and rein attachment. The small loop behind the top slot accommodates a curb strap (attach with two curb hooks). The top bridle ring will fit standard ⅝" leather found on most headstalls. The bottom rein ring has recently been updated to fit slobber straps up to approximately 1 ¾". The knob on the top of the rein ring is for decoration—it has no function.

The hooks make this a much more versatile version of the dee without hooks. Attaching the headstall to the top hook holds the bit in the correct position instead of allowing it to slide around the bridle cheek pieces. Attaching the reins to the rein hooks allow the rider to lift the cheek and use the Independent Side Movement™ of the mouthpiece. Using the hooks does not add leverage but allows the rider to transition from a direct rein action to indirect action without changing the bit. Adding a curb strap (using a Myler curb strap kit) incorporates curb pressure. Curb pressure is recommended for ported mouthpieces.

Size: 3" offset ring

Action: Direct rein action when reins are not attached through rein hook. Indirect rein action when rein is fixed on rein hook.

Discipline: Primarily Western

Degree of Leverage: Little to no leverage when the hooks are used